New Day Laser Cutting Machine laserpecker 2 pro.
Correct operation of laser cutting machine is conducive to safe production, which is very important for enterprises. In addition to being familiar with the correct operating procedures, you should also be familiar with maintenance laserpecker 1.
Operation Technology of laser cutting machine laser cutter.
1. Wear labor protection articles according to regulations, and wear protective glasses near the laser beam according to regulations.
2. equipment start-up operators shall not leave their posts or entrusted management, if it is really necessary to leave should stop or cut off the power switch.
3.fire extinguishers should be placed within reach; Not processed to turn off the laser or shutter; Do not put paper, cloth or other flammable materials near the unprotected laser beam.
4.Keep the laser, bed and the surrounding site clean and tidy, no oil pollution, workpieces, plates, waste according to the provisions of stacking.
5. After starting the machine, manually start the machine in the X and Y directions at low speed to check and ensure that there is no abnormality. 6. After entering the program of the new workpiece, try to run the machine first and check its operation.
6. when working, pay attention to the operation of the machine, in order to avoid cutting off the effective travel of the machine or two collisions caused by accidents.
7. when using gas cylinders, should avoid extrusion welding wire, so as to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder monitoring regulations. It is forbidden to expose cylinders to sunlight or near heat sources. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
Maintain in accordance with high pressure safety regulations. Follow regulations and procedures for maintenance every 40 hours or weekly, every 1,000 hours or every 6 months.
Laser cutting machine maintenance
Cleaning the water tank: firstly, turn off the power supply, unplug the water pipe at the water inlet, let the water in the laser pipe automatically flow into the water tank, open the water tank, take out the water pump and remove the dirt on the water pump. Clean the water tank, replace the circulating water, return the water pump to the water tank, insert the water pipe connected to the water pump into the water inlet, and tidy up the joint. Start the water pump separately and run for 2-3 minutes (fill the laser tube with circulating water).
Fan Cleaning: fan cleaning time is long, will make the internal accumulation of a large number of solid dust fan, so that a lot of noise fan, is not conducive to exhaust and deodorization. When the suction of the fan is not enough to exhaust the poor, the first adjacent power off, will be removed on the fan in and out of the air duct, will be inside the dust removal. Then turn the fan upside down. Then pull the blades inside until clean, then install the fan.
